Fascia is the long board that runs along the lower edge of your roofline — it’s what your eavestroughs attach to, and it’s the first thing that takes damage when water backs up or ice builds along your roof edge. In Winnipeg, we see rotting fascia constantly, especially on homes with older wood fascia boards that were never capped with aluminum. Once the fascia starts to go, your eavestroughs pull away, water runs down behind your siding, and the damage spreads fast. Modern Renovations installs, repairs, and replaces fascia boards across Winnipeg and surrounding areas, and we do it right so the problem doesn’t come back.
Fascia serves two critical functions: it seals the gap at the end of your roof rafters to keep moisture and animals out of your attic, and it provides the mounting surface for your eavestrough system. When fascia is solid, everything works. When it starts rotting or pulling away, your eavestroughs lose their support, water overflows behind the gutter, and it begins soaking the wall below.
The most common cause of fascia failure in Winnipeg is water. Ice dams push melt water back under shingles and into the fascia board. Overflowing or poorly sloped eavestroughs keep the fascia constantly wet. And on older homes where the original wood fascia was never wrapped in aluminum, decades of direct weather exposure eventually breaks the paint seal and the rot sets in.
We see this most on 1960s and 70s bungalows in areas like St. Vital, Garden City, and Fort Garry — homes where the original wood fascia has been exposed to 50+ years of Manitoba weather with nothing but paint protecting it.
When the existing fascia is rotted through or structurally compromised, we remove it completely, inspect the rafter tails behind it for damage, and install new fascia boards. We typically install aluminum-wrapped fascia, which gives you the structural strength of the board underneath with a maintenance-free aluminum face that never needs repainting.
If the damage is limited to a small section — maybe where an eavestrough was leaking or an ice dam formed — we can replace just the affected boards and match the rest. We’ll be honest about whether a targeted repair makes sense or whether the rest of the fascia is close enough to failing that it should all be done at once.
If your existing wood fascia is still structurally sound but the paint is failing and you’re tired of repainting it, we can wrap it in pre-painted aluminum. This seals the wood from weather exposure and gives it a clean, finished look that lasts for decades. It’s a practical middle-ground option that extends the life of your existing fascia without a full replacement.
Your fascia and eavestroughs are a system. If we’re replacing fascia on your home, it usually makes sense to assess your eavestroughs at the same time — and vice versa. We often do both together because it’s more efficient (one set of scaffolding, one crew, one visit) and it ensures the new eavestrough is mounted to solid, level fascia with proper slope from the start.
Fascia work requires crews who are comfortable working at height and who pay attention to the details — clean cuts, tight joints, proper flashing where the fascia meets the roof edge. Our exterior crews handle fascia alongside soffit, siding, and eavestrough installations every day. Owner Josh Vokey holds every project to the same standard and makes sure nothing gets missed.
Every fascia installation and repair is backed by our 5-year workmanship warranty.
Look for soft spots, peeling paint, visible rot, or sections where the eavestrough is pulling away from the house. If you can press your finger into the fascia and it gives, the wood is rotting from the inside out. Don’t wait — the longer it sits, the more damage it causes behind the board.
If both are in rough shape, yes — it’s more cost-effective to do them together since the crew is already set up and working on the same area. If your soffit is in good condition and only the fascia needs attention, we can do just the fascia without disturbing the soffit panels.
Aluminum-wrapped wood fascia is the most common and practical option. The wood provides the structure, and the aluminum face protects it from weather. Full aluminum or composite fascia is another option for homeowners who want zero maintenance, though it’s less common on residential homes.
If your fascia is starting to show damage or your eavestroughs are pulling away, don’t wait for the problem to spread. Give us a call and we’ll come take a look. Modern Renovations serves Winnipeg, East St. Paul, West St. Paul, Niverville, Steinbach, and communities across southern Manitoba.
